Daily Maintenance Of Superfine Grinding Machine

In order to extend the service life of the ultra-fine grinding machine, the key is still the daily maintenance and service. The following is a summary of some specific matters for the maintenance of ultra-fine grinding machine, to help the majority of users.

1. During the use of the pulverizer, special personnel shall be responsible for establishing the post responsibility system and operating specifications. The operator must be familiar with the performance, use requirements and operating procedures of the machine. New personnel must receive technical training before taking up the post;

2. The lubrication work for the transmission part of the ultra-fine grinding machine accessories must be done in place. The lubricant should not be added too much or too little. The lubricant selection should be correct in winter and summer, and the cleaning work of this part must be paid attention to. The impurities will pollute the lubricant and affect its lubrication effect. It is best to thoroughly clean and add new lubricant regularly according to the working intensity.

3. Frequently check the backwash air pressure of the bag filter to prevent the filter bag from clogging, and the current drop of the fan will affect the output of the equipment. Usually, pay attention to the tight sealing of the pipe joints to ensure no air leakage; Regularly check the dust collector, and replace the filter bag if it is damaged, so as to avoid pollution caused by dust leakage; The drain switch at the lower part of the oil-water separator should drain water 2-4 times every 8 hours.

4. Check all parts and components frequently, and fasten them in time if they are loose to avoid accidents; If wearing parts such as grinding roller, grinding ring, disc mounting, shaft pin are found to be seriously worn, the wearing parts shall be replaced at the same time to ensure normal production; The muffler shall be cleaned regularly to avoid excessive resistance affecting the system air volume;

5. The external working environment of the ultra-fine grinding machine should be protected from outdoor production. Exposure to the sun and rain will cause different degrees of damage to the mill. If there is water in the body, the effect will be worse. The external leakage surface of the mill should also be coated with anti-rust grease. If any rust is found, it should be treated immediately and anti-rust repair measures should be taken.

6. The working hours of the mill should be well planned. Machines and people should avoid overwork as much as possible. Overwork not only has low production efficiency, but also causes great damage to the machine and shortening the service life.

If the maintenance is done properly, the failure frequency of the ultra-fine pulverizer will be properly and effectively reduced. If the occasional failure is repaired in time, it can get twice the result with half the effort. Maintenance is important for the high-quality pulverizing equipment. The quality is determined by the manufacturer, while the maintenance is in the hands of the manufacturer. If the two are combined, the effect will be ideal.