Routine Maintenance Of European Rough Grinding

European rough grinding is a equipment engaged in medium and fine crushing of materials. It is mainly suitable for crushing soft and hard ores with compressive strength not higher than 320MPa (MPa). Every mechanical equipment has a service life, but as long as the daily maintenance is good, it can increase its service life. Let's take a look at how to maintain the rough grinding of the European version in this article.

European rough grinding mainly consists of casing, rotor, bearing iron, grate bar and other components. The main machine drives the main shaft by clicking and V-belt, so that the rotor rotates. The hammer head is stretched around by the centrifugal force generated by the rotation. After the large material enters the crushing chamber from the feeding port, it is broken by the high-speed hammer. During daily work, pay attention to the wear degree of each part. If the parts are seriously worn and cannot be used, they must be replaced immediately, or the daily use of the crusher will be affected.

The European version of coarse grinding integrates fine crushing, drying, grinding, powder selection and transportation. It does not need additional external drying, powder selection, lifting and other equipment. Before each shutdown, it is necessary to ensure that the materials in the crushing chamber have been completely broken and there is no residue before the shutdown. The next time you start the machine, you should idle for a few minutes, and then crush the material into the crushing chamber.

Always pay attention to lubricating the friction surface in time to ensure the normal operation of the machine and prolong its service life. The lubricating grease used shall be determined according to the conditions such as the place of use and temperature. The lubricating grease added to the bearing seat is 50-70% of its volume and must be replaced every three months; When replacing the new oil, clean gasoline or kerosene must be used to clean the dirt in the bearing and bearing seat. Before starting the machine, grease must be added when the bracket is in contact with the bracket pad.

After buying the equipment, remember not to keep the equipment running for 24 hours continuously. Although the equipment is not human, it also needs to rest. The overload work intensity, even the machinery and equipment can not bear.